F698-2RS 8x19x6mm Sealed, No-Shoulder-Needed Bearing for Cash Handling Machines Flanged Ball Bearing

No-Shoulder-Needed Flange Design
The F698-2RS (8x19x6mm) carries an integral flange that locates and retains the bearing directly in a through-bore, removing the need for a machined shaft shoulder or a separate retaining clip.

Built for Cash-Handling Mechanisms
This flanged format is a common fit inside cash-handling and note-recycling machines, where compact axial positioning inside a plastic or thin-metal housing is a routine design constraint.

Rubber-Sealed for Continuous Banking Use
The RS seal keeps out the fine paper and metal dust generated by high-cycle bill and coin transport mechanisms, supporting long service intervals in equipment that often runs unattended.

Simplifies Assembly and Reduces Part Count
Because the flange itself sets axial position, OEMs can simplify the surrounding bracket design, cutting one machining step and one fastening component from the final assembly - a real cost and time saving at volume.

Support for Financial Equipment OEMs
Drawings, material certificates, and sample units are available to support the qualification process financial equipment manufacturers typically require before approving a new bearing supplier.